BS EN 16579:2018 – GOALPOST SAFETY STANDARD
This is the current standard that all football and rugby posts should be manufactured in accordance with as BS 8462 has been withdrawn. It is crucial that the end user should take responsibility for the installation and correct use of all goal post products. Users should follow the relevant guidelines and pay particular attention to the care and maintenance instructions provided. In particular heavier free standing movable goalposts must be adequately anchored at all times in use , during storage, Installation or movement. Installation should always be carried out under the supervision of a competent person using due diligence and risk assessment. Installation of sockets must be solid, not allow any movement and installation should be carried out by appropriately qualified personnel with grounds care experience. Children should not be allowed to assemble or move goalpost products under any circumstances. Do not install fixed position steel goalposts with children present. Any joints on the goalposts including welds should be checked regularly for signs of wear. Any goalposts damaged in any way should not be used and appropriate remedial action should be carried out before they are brought back into use. Paintwork on goalposts should be checked regularly especially steel posts and damage should be treated promptly as set out on manufacturer’s care & maintenance information. IF IN DOUBT ABOUT THE SAFETY OR STABILITY OF AN ITEM OF EQUIPMENT – DO NOT USE IT. You can contact the technical director at ITSA GOAL for help and guidance at any time. (mobile 07974745768)
DRIVING SAFETY STANDARDS
ITSA GOAL are the oldest plastic football goal manufacturer in the world . They are the leading innovator in football goal post safety and design. The company was the first goal post manufacturer to represent the U.K. on the European Normalisation (CEN) Safety Standards. Prior to this committee being set up no one in the industry had looked into the issues surrounding goalpost safety. The introduction of plastic football goals for children by ITSA GOAL made a huge difference and ensured young children at long last could play football in proportional safe football goals.The EN748 and subsequent BS 8462 safety standards were eventually put in place after the death of Jonathan Smith in 1991 when the BBC program “That’s Life” highlighted the serious injuries caused by heavy and poorly designed goal posts. BS 8462 has now been withdrawn and the new standard BS EN 16579:2018 has replaced it. The momentum and drive towards safer lightweight football Goals by our company has gone a long way towards reducing serious injuries to children around the world. Sadly fatalities continue with heavier goalpost frames that are still in use, and that is why we are fighting to remove all heavy freestanding steel goalposts used by children. Our company has been involved more than most to try and introduce safer football goals. When you have a distraught mum crying “if only my son had been playing with your goals he would still be alive” it does focus the mind somewhat. The lessons have still not been learned and other young footballers are still being fatally injured by heavy freestanding goalposts. We commissioned a University report on the dangers of football goal posts toppling and the overwhelming conclusion was that the mass of the goal and the falling force generated by that mass from the fulcrum point was the main reason why goalposts cause fatalities. Our mission has been to reduce this total mass on all goal posts and in particular free standing movable goalposts to a safer limit. We put safety before profit.
The main dangers with football Goalposts as we see it are:-
Fixed position goalpost storage
Fixed position heavy steel goalposts being removed from the ground intact (usually as bolts get rusted up and cannot be easily removed) have crossbars still attached to uprights and if they are stored against a wall, fence or shed then it is possible they could topple forward. This has been the cause of fatalities around children. This is extremely dangerous. Even intact goalposts when stored with crossbar to the floor can still be dangerous especially when multiple sets are lent and stored together as heavy steel falling uprights can be just as dangerous. Such goalposts must be separated (uprights from crossbars) dismantled, made safe and stored away securely preferably at ground level or as low as possible.
Fixed position goalposts in sockets that are bolted need to have the crossbars secured from the sides to the uprights and not dropped onto the top of the uprights and bolted. Goalpost crossbars secured in this way to the side are safer as nuts and bolts cannot be removed without the whole frame being lifted out of the ground sockets which is something a child cannot do without lifting the whole goal frame.
Steel goalposts that have crossbars that just drop into uprights and only rely on nuts & bolts to keep crossbars attached can be easily undone by vandals allowing the crossbar to be lifted off and dropped and the weight of a steel crossbar is heavy enough to cause serious injury or a fatality. The other common problem with this design is that the ground movement and upright position changes making hole alignment difficult. If numerous fixed position goalposts are used then it is imperative that every goalpost upright goes in the right hole at the right end of the pitch at the right side of the goal and on the right pitch every time they are re installed. This is why all over the country goalpost crossbars are not correctly bolted and in some case we have seen dropped on without any nuts & bolts at all. Unlike the anti-vandal goal which allows any upright or crossbar to be used anywhere It only takes one mix up with one upright to ensure all nuts & bolts may be unable to be fitted on the remaining goalposts. Ground sockets for steel goalposts need to be secure and lockable in open areas especially council pitches not just left open for rubble or animals or children to step into. Every goal should provide a secure lockable socket cap system that ensures nothing can be put inside and nothing can fall or become trapped inside.
Heavy steel Free standing goals – dangers
Heavy steel freestanding goalposts toppling forward onto the stomach, head or chest is one of the major factors that cause serious injury.(See our blunt trauma research) The accidents often show this happening whilst goalposts are being set up or moved around and at times when they may not be anchored. We have experienced this type of accident however as we make light weight free standing goals nothing more than a slight bump resulted. (See comments at the bottom of the page from Denis Hickford )
ITSA GOAL are the only football goal post manufacturer in the industry pioneering lighter freestanding goal posts. This type of lightweight freestanding goalpost should be the first choice for Junior Football clubs. It seems a ridiculous state of affairs that these were outside the BSI safety standards yet heavier less practical freestanding goal posts were included.
Strong, sturdy long lasting alloy freestanding goals to a weight/mass that cannot fatally injure a child can be manufactured. The goalpost industry has to change. We as a company have never had one of our lightweight crossbars bend or break and we argue to the standards committee and the Football Association that it is not necessary to use heavy steel post sections for children’s freestanding goalposts.
Football goal hand, finger, head, torso & foot entrapment
Entrapment, especially on swinging hinged sided goal frames is a problem. A business colleague lost three finger ends with such goals when heavy steel sides swung in wards and the goal collapsed on top of him during a game. According to the Football Association’s own report it states hundreds of accidents a year are reported in Accident & Emergency departments that are caused by football goalposts. These accidents must be serious enough to need medical attention so whatever is currently causing these incidents shows why radical improvements were needed to BS 8462. We are glad to report that finger entrapment is now included in the new standard BS EN 16579:2018 and that BS 8462 has been withdrawn.
Folding goals that have sides that dislodge and swing about are unstable and may be unsafe. Buttons, pins and spring sided frames are just not good enough. All side frames need to be securely locked especially around children during play, whilst being moved and when stored.
Freestanding goalposts with un-welded corners.
A number of freestanding goal frames expand apart and leave dangerous sharp corners that need constant tightening and alignment of nuts & bolts. Our influence has meant that many have changed and now weld corners yet the mitred versions are still being sold as they are less expensive to make. Heavy freestanding goals with integral weights or rollers on the rear of the goal frame are designed in such a way that every time they are moved the nets may become entangled, the structure is weakened as nuts & bolts become loose. These goals in our opinion need to be tested over a much longer period than the one minute required in the standards. Integral weighted goals may need better designed frames that do not work apart as the stresses on these freestanding goals when moved is much more than other types of goals. In our opinion a radical re think about this type of goal needs to take place. We do not make or supply such goals and would never have one on our football pitch as it would compact the surface and may well rut and damage the playing surface.
Football Goalposts with wheels
Wheels on freestanding goals appear to be inadequate for the job as many just buckle over, puncture or lose a rubber tyre at which time they may leave knife like edges. We believe that wheels should be always be removed from goalposts prior to play as they are often located in dangerous positions, have numerous finger and foot entrapment areas and players can collide into them and sustain serious injury. Goalpost wheels buckle and bend outwards and collapse due to the fact that freestanding goals are pulled from side to side more than they are pushed backwards and forwards. This is why you see missing wheels, punctured wheels and dangerous exposed wheel brackets.
Free standing Goalposts – Counter balance Weights
The main problem as we see it are sandbags as these can split and the weight can become less than is required to hold a goalpost securely. The actual weight can vary from bag to bag as they are often left to users to fill and secure. Any form of counter balance weight that can change should be discouraged so the use of water and sand should be avoided. These types of weights may leave users with a false sense of security that they are using the correct weight when they may not be. Only weights that cannot be adjusted should be used so that users know the weight is correct at all times. Slot in water holders into back ground frames will add weight to the frame but may well not meet the test requirements of the BS EN 16579:2018 standard. In our opinion the topple test is far too high for children’s goals which leads to more weights being used than are actually needed and this results from our own experience that users only using two weights on each corner as it is too much trouble to use more. They see that two well-designed weights will do the job if they are sufficiently heavy and are correctly positioned .The topple test in our opinion, if the maximum weight of the goals is reduced, should be much less on children’s goals and should equate to the same force that say four young lads could exert by swinging on the crossbar. This would probably equate that the two counterbalance weights on the rear corners are actually sufficient to do the job but only on the lighter safer freestanding goalposts. At the moment this seems to be happening at clubs and it seems to be seen as the accepted way of doing things.
On the heavier freestanding goal posts over 45 kilos in weight this is potentially dangerous. With lighter safer goalposts that cannot kill the weights would be used on hard surfaces more to stop the goal from moving around rather than to be the main force to prevent toppling.
Counter balance weights can be heavy and they should be designed in such a way as to allow them to break down to the maximum health & safety lifting limits which is around 25Kilos. They should always be stored at ground level if possible. Around 112 kilos of weight on the rear ground frame is needed to pass the current safety toppling test.
Hi John,
I have just read an article on the new guidelines for goalposts and note that some of your lighter aluminium goalposts do not now meet the proposed current BSI safety criteria. This is ridiculous!
As you know we purchased several goalposts from you over the last five years and to date we have not had a single serious accident or problem with your football goals. We try to stop kids jumping up onto the crossbar, but it is very difficult, especially when away team goalkeepers do it during a game. However, out of all the sets we have, not one crossbar has even the slightest bend in it. We always get complimented on our goalpost and it is a fact that our club appears to have the best equipment in the area. Last year we did have an accident where a goalpost fell onto a youngster. This was because the children started playing in the football goal while it was still being erected. I am pleased to say that although the youngster got hit on the head he only had a slight bump and an ice pack quickly sorted it out.
I would also like to let you know that a few years ago we were sued by a dog walker. We play in a public park and his dog got its leg down a goalpost socket after the socket cap had been stolen by vandals. (not your goalposts I might add) .The dog broke its leg which resulted in hefty vets bills. I’m glad to say that the dog recovered but we had a large claim on our insurance. After this incident we decided to switch to free standing goalposts and fill in all sockets on the park which has proved to be a great decision. This was quite an expense for us but we purchased your freestanding folding goalposts that lock and have not had any problems since. Our goalposts have to be carried nearly 100 yards every Saturday and Sunday and a lightweight goal is essential to make this feasible.The ITSA GOAL posts are the only goalposts light enough and safe enough for a few children to carry them out on their own supervised by an adult.
If the standard is changed we would be faced with purchasing heavier goals in future which is going to affect our finances, as I assume they would be much more expensive, but also would be completely unnecessary. The goalposts from ITSA GOAL are safe and more than adequate to do the job.
Regards, Dennis Hickford – Woodbank Junior Football Club. July 2012
BS EN 16579:2018 NOW INCLUDES LIGHTER SAFER GOALS
Common sense has prevailed in the new standard over the manufacturers who only want to offer heavier free standing goalposts.
Clubs no longer have the problems of constant maintenance, the additional work and dangers of moving heavy frames about, constant wheel problems, levers that are tensioned so much they can strain the wrists to release them, finger and foot entrapment areas, constant punctures, ruts in pitches from moving heavy goals around and the worry if one ever did come apart and fall on a child what damage it may inflict.
Lighter safer goals are now available within the goalpost standards thanks to our campaigning for change.
Visit: https://www.soccertackle.com/football-goalpost-safety-23-w.asp for more information
